TS session: almost same with mdual new TS lab 1. Easy VACL 2. R15 apply next-hop-self under BGP group name (nei iBGP next-hop-self) 3. My question was traceroute from SW110 to 10.2.200.254 & 10.2.201.254 output must be: 1 x.x.x.x 2 x.x.x.xx x.x.x.xy 3 x.y.x.x 4 y.y.y.y 5 y.y.y.yy 6 y.y.y.xy
Second part traceroute from SW211 to 10.1.200.254 & 10.1.201.254 Same ideal output
Solution 3: under interface apply ‘ip load per-packet’
4. My question traceroute from Server2 to R40. Trace was success route though MPLS but question output route though single ISP router
Problem: R20 & R21 have same local preference 100 (pre-config) Solution: R21 increase higher local preference
5. Same as CC 6. My question User3 request DHCP from R30 Problem: SW300 & SW301 Solution: int vlan 2000 Ip dhcp relay info trust 7. Same as CC 8. MPLS my question Server1 traceroute to SW500. Multi error spotted Problem 1: R1 Int lo0 Missing ospf 1 area 0 Problem 2: R3 Route target import <missing R15> Problem 3: SW111 Adjust OSPF cost 1
9. R15 advertise User1 IPv6 LAN but solution not working My solution: R15 BGP xx Add IPv6 Redistribute ospf 1 inc match int ext
10. Single NAT issue my question telnet from NAS to R25 (loopback address) R25 have 3 x loopback I Guess lo0, lo123 and lo2323. Question was NAS telnet to R25 (loopback 2323 address). Solution: only apply single NAT command Ip Nat outside source static <R70 WAN ip> 201.99.25.25
Diag: 3 question 1. Access SW3 replacement Problem: SW1 (vtp server) vtp vlan number not tally with SW3 (vtp client) Solution: ask operation to sh vtp pass at SW3 2. DMVPN 1st report device point to R15 Solution: R16 increase subnet mask 3. uRPF (no time to answer) Click and drag 8 selection Issue due to uRPF strict mode
CFG: vrf config, many incomplete config. My advise ping test before start ospf or eigrp config also watch out for ip vrf forward xxx *missing command*.