CCIE R&S v5 Exam Review on 22 February 2015
Config lab:-Same as workbook i got Lab 1.2Diagnostics:-Same as workbook PDF
Acess vlan wrong
PPP ipcp default missing on r17
Max-mteric on R5
bandwidt command and metric weight
5.Trace to internet:-
Metric R-21 route map
Next hop wrong in route-map
R-15 redistribute connected
nhrp shorcut missing on spokes
The most tricky of all.
They have asked for traceroute from one branch to other and to internet from one bracnh
I had 5 faults in this ticket.
1.Deafult originate missing on r10 in OSPF
2.Default orginate mssing on r7 in BGP
3.Nat outside on e0/0.125 on R7 and R8
I thought i resolved but out of curiousity i wanted to test failover by shutting R7….And to my surprise it didnt work… then found 2 more faults.
4.MPLS label switching issue as R4 didnt have mpls label generated for R6.R6 and R4 were learning each other route via eth 0/2 which didnt have MPLS IP.this results in failover for R7 not working.
Basically i increased the cost on e0/2 so that routes get learned on MPLS enabled interface.
5.Int eth 0/0.123 and eth 0/0.124 ips on R4 not addvertised in their VRf.
Once i fixed above 2 , failover worked fine…
Nat traversal disabled
Ip nhrp map wrong
NAT configured wrong on r23.
P:s I might not visit the forum till my next CCIE>