CCIE R&S v5 Exam Review on 28 September 2015

1 host to ping and trace server ( access-list on vlan 12)
2 encapp frame-relay
3 passive interface r12
4 wrong router-id on r 22 for ospf
5 unable to load balance 8.8.8.8 accross r 4 and r 6 (ibgp peering missing on r6 for rr ,mpls missing on r2 i check all metric are the same on r12 for 8.8.8.8
6 ipv6 strictly do not modify ipv6 acl or remove just peer using ipv4 and advertise network
7 dmvpn all spokes missing nhrp short cut and access-list on r14 denying r18
8 missing nei peering on r3 , r7 and r4 ,r8 , r4 and r6 added ip ospf cost ,still wont fail over to r8 ping dropping at r6 from pc107
9 tunnel up crypto, session down check every thing still cant get it up ,check nat is good ,when i remove tunnel protection on both ends it work , any suggestion
10 fix ip dhcp enable on nas getting wong ip address and host mapping missing on r23
config rtp ,name mode eigrp no authen and no vrf

finished config wired thing happen on ipv6 config of the loopbacks are like CC1E ::xxxxxx/128 from all domain they not pingable from
ospv3 domain when i remove the address in panic i try to add it back it wont let me wierd
every ping was working until i config nat section and ping stop working dont know why
multicast configured in and out wired unable to ping every config looks ok added offset-list on r17

practice more TS cause according to proctor point are not awarded for partial fix and proctor does not reboot your rack when grading