TX 75035,USA
live:cciernstricks

CCIE R&S v5 Exam Review on 29 October 2015

CCIE Real Lab Workbook

CCIE R&S v5 Exam Review on 29 October 2015 No ratings yet.

Dear All, I passed my CCIE LAB TODAY. i really thank to cciereallabworkbook

Diag:

SW3 VTP password
DMVPN R16 increase subnet
ticket 3 did not solved 🙂

Config very much straight forward, After reading all the Q i was sure that i am going to my dream exam, and no one can stop me…

Section 1 L2 same
WAN swithing same. same
OSPF in AS12345 Configure R1 should act like stub router in OSPF,
EIGRP in AS34567 Using a single command on one switch
EIGRP in AS45678 nothing change same as discussed
EIGRP in AS 65222 nothing change same as discussed
BGP in AS 12345 same old story
BGP in AS 34567 same but need to reditribute default from R9 & R1
BGP AS 45678 and 65222 same nothing change default route from R15
BGP routing policies R6, R7, R12, R13, R14 preconfigured, however Q was asked R13 shld prefer AS2002,
redistributed connected so that all e0/0 interaface ip can ping other Regional service providers.
Rest same.
IPV6 OSPF & BGP same
Layer 3 multicast nothing new
MPLS VPN part 1 & Part 2 i complted with ospf section.
DMVPN & Encryption same it took me some time, since i wrong mentioned tunnel source.
Infrastructure security banner
Network Security Port security
Infrastructure Services same ssh
Network Services nat on r20, NTP ipv6
Guys make sure, in L2 part you check tunk, since if its default desirable, you wont able to ping routers. starting i though there is l2 issue, however after changing to dot1Q my direct connected network started ping.

Please rate this